New design taking advantage of the Dogbone design so the moulds can be stacked.
This model has overall dimensions of 162.5mm x 112.5mm x 31.25mm with two casting chambers, each measuring 112.5mm x 37.5mm x .12.5mm. The blanks can easily be end trimmed and squared up on a table saw, if so desired.
A release agent must be used due to the rigidity of the molds. Ease Release 200 from Mann is highly recommended. Just spray the release agent into and on top of the chambers ensuring complete coverage and allow to dry before pouring your resin.
Apply a release agent to the rubber plugs to keep them free of any resin buildup caused by potential spillage.
A rubberized dead blow hammer will help the demold process greatly. Lightly rap the bottom and sides of the mold once your blanks have fully cured, then turn the mold over and lightly rap the mold ends against your work bench top to see your blanks release.